Replace the ORC, perform the Airbag system verification. Failure to take the proper precautions can result in accidental airbag deployment. DodgeB0020-13 Dodge DTC B0020-13 Make: Dodge Code: B0020-13 Definition: 1st Row Left Seat Mounted Side Squib 1 - Circuit Open Description: When powered, the Occupant Restraint Controller (ORC) sends a test current to the squibs to verify the integrity of the squib and wiring. Yes, if the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Measure the resistance of the left seat squib line 2 circuit between the left side seat squib airbag connector and the SRS load tool adaptor 8443-32-L cavity C2-5. Check left seat squib line 2 circuit for an open
![left side seat deployment squib 1 left side seat deployment squib 1](https://liveworkdream.com/wp-content/uploads/2019/03/032119w_squib-5796.jpg)
No, repair the left seat squib line 1 circuit for an open or high resistance. Measure the resistance of the left seat squib line 1 circuit between the left seat squib airbag connector and the SRS load tool adaptor 8443-32-L cavity C2-6. Check connectors, clean and repair as necessary.Ĭonnect the SRS load tool adaptor 8443-32-L to the ORC connectors. Disconnect the SRS load tool Kit 8443A and SRS load tool jumper from the left seat squib airbag connector. Turn the ignition off disconnect the 12 volt battery and wait two minutes before proceeding. Check left seat squib line 1 circuit for an open
![left side seat deployment squib 1 left side seat deployment squib 1](https://jeepspecs.com/wp-content/uploads/2021/02/airbag2.jpg)
Replace the left seat squib airbag, perform the Airbag system verification. No, turn the ignition off disconnect the 12 volt battery and wait two minutes before proceeding. With the scan tool read the active ORC DTC. Turn the ignition on, then reconnect the 12 volt battery and wait two minutes before preceeding. Do not place an intact non-deployed seat squib airbag facw down on a hard surface, the airbag will propel into the air if accidentially deployed.Ĭonnect the SRS load tool kit 8443A and SRS load tool jumper to the left seat squib airbag connector. Disconnect the left seat squib airbag connector. Check for open squib circuits in left seat squib Airbag
![left side seat deployment squib 1 left side seat deployment squib 1](https://ars.els-cdn.com/content/image/3-s2.0-B9780080970974000102-f10-18-9780080970974.gif)
Turn the ignition on, with the scan tool read the active ORC DTC. The ORC will set this DTC if it detects an open or high resistance on the left seat squib circuits.
Left side seat deployment squib 1 code#
B1C29 code - The Occupant Restraint Controller (ORC) monitors the resistance of the left seat squib circuits.